(OPS203.1) Steam Turbine Familiarization/Operations - Industrial ST
Designed to provide a basic understanding of the equipment and its associated auxiliary systems.
Description
The Siemens Energy Industrial Steam Turbine – Generator Set Familiarization and Operations training course is designed to provide a basic understanding of the equipment and its associated auxiliary systems. The training will support the installation, startup, and operations of commercial power projects. Managerial, professional and technical personnel perform functions vital to the safe and efficient operation of a power plant. In order to fulfill their job responsibilities, they require an understanding of the Siemens Energy turbine-generator system and its interrelationship with the associated balance of plant systems. The goal of this course is to provide this understanding customized to each customer’s specific site. All training programs are limited to the Siemens Energy scope of supply.
Course Content
The following topics are representative of those covered in this course. Actual course content will be customized to the specific plant configuration. Classroom lecture, guided discussions, and system walk downs (only if conducted on site) when practical will be utilized. Some out of class study may be assigned. All required instructional materials are provided to each student.
- Introduction- Industrial Steam Turbine - Generator Set Familiarization
- Steam turbine plant overview
- Definitions and nomenclature
- Safety precautions
- P&ID drawing review
- Steam Turbine (applicable turbine) & auxiliary systems (as applicable in scope of supply)
- Basic steam turbine description
- Backpressure
- Condensing
- Induction
- Extraction
- Steam turbine assembly
- Casing, Inlet, Exhaust
- Inlet Controls
- Rotor
- Blading
- Blade Carriers
- Bearings
- Seals
- Turning Gear
- Coupling
- Gland seal / Gland Exhaust
- Lubricating oil
- Hydraulic control oil
- Cooling sprays and drains
- Over-speed trip/ Over-speed protection control
- Generator & Exciter
- Stator
- Rotor
- Windings
- Excitation
- Generator cooling (Air to air, Total enclosed water cooled, H2)
- Hydrogen cooled generator support (H2/CO2 gas, H2 seal oil)
- Introduction- Industrial Steam Turbine - Generator Set Operations
- Steam turbine-generator system
- Speed Control
- Load Control
- Steam Control (As Applicable)
- Extraction Control (As Applicable)
- System operational concept
- Control System
- Control logic diagrams
- Turbine System Operating Procedures
- Pre-start checks
- System startup
- Load changing procedures
- Generator Capability Diagram
- Voltage Control
- Generator Protection
- Operational checks
- Operating parameters
- Operating limits
- Abnormal conditions
- Shutdown Procedures
- Preventative Maintenance Considerations
- Service bulletins (introduction)
- Warranty policies/ Typically requested information
Intended Audience: Ops
PLEASE NOTE: The course length is provided as an estimate only. Actual course length may vary based on student experience level and participation.